Rose CrystalView Plus Bedienerhandbuch PDF herunterladen (Seite 25)

CRYSTALVIEW PLUS INSTALLATION AND OPERATIONS MANUAL

Keyboard command descriptions

Command mode – [L-Ctrl] + [L-Shift] + [F10]

Entering the command mode sends the remote units keyboard instructions

to the CrystalView Plus instead of the connected computer. In the

command mode, the yellow LED on the remote units RJ45 connector for

channel 1 will light indicating that the unit is in the command mode. The

keyboard status LEDs (Num lock, Caps Lock, and Scroll Lock) will flash

indicating which channel is selected. The Command mode

automatically times out after 30 seconds of inactivity, saves all settings, and

returns the keyboard to normal functions.

Number of keyboard

status LED flashes

Video channel selected

Channel 1 (Default, all models)

Channel 2 (Dual & Quad models)

Channel 3 (Quad models)

Channel 4 (Quad models)

Slow flashes

Channel 0 (All channels)

Table 2. Channel select

Exit Command mode and save – [Esc]

Pressing the Esc key while in the command mode will save all configuration

changes made and exit the command mode.

Exit Command mode without saving – [L-Shift] + [ESC]

Pressing the left shift key and the Esc key while in the command mode will

exit the command mode without saving any configuration changes.

Select Channel 1 – [1]

Pressing 1 while in the command mode selects channel one and all

configuration adjustments apply to channel 1 only. Keyboard status LEDs

flash once.

Select Channel 2-4 – [2, 3, or 4] (Dual and quad models only)

Pressing 2, 3, or 4 while in the command mode selects that channel and all

configuration adjustments apply to the selected channel only. Keyboard

status LEDs flash twice for channel 2, three times for channel three, and

four times for channel four.

Select Channel 0 – [0] (Dual and quad models only)

Pressing 0 (zero) while in the command mode selects all channels and all

configuration adjustments are applied to all channels.

This is especially helpful if all cable lengths and types used for all channels

are the same.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 43 44

Keine Kommentare

Rose CrystalView Plus Bedienerhandbuch Seite 25